Page 1
Page 2
Page 3
Page 4
Page 5 Steps 23 to 28
Once the sleeve is in the control
arm bushing, add the bushing caps
to both ends of the bushing.
This photo show a hammer helping
the caps back onto the sleeve.
See fig.18
The rear bushing or "strut
bushing" goes on next.
First the washer, then the
new sleeve that came with
the bushings.
See fig.19
Cover the sleeve with the
green poly lube. Lube inside
the washer also!
See fig.20
Add the large half of the
control arm bushing (strut
bushing) with the stepped
end away from the a-arm.
See fig.21
When installing the a-arm into
the k-frame use the reverse order
that you took it apart. The small
part of the bushing goes
with the flat part toward the
k-frame. The correct order
is shown.
See fig.22
HOME MOUNTS SUSPENSION TECH HELP!
Go to page 5