polyurethane Neon engine and transaxle mounts

Performance Products for FWD
Chrysler, Dodge, Plymouth, Shelby

Installation Instructions
Engine Mount Inserts for
Avenger and Chrysler 200 with 3.6

Polyurethane inserts for the front engine
mount. These are softer, 70 durameter inserts, for
performance, yet no vibration.

Set includes two form fitting inserts.

Part number PB1040

Fits 2011, 2012, 2013 Avenger and Chrysler 200 with the 3.6 Liter V6

This is what the stock engine mount looks like for the 3.6 engine. (red arrow) You will be lowering this mount and and bracket from the car. One insert goes into one side and one insert goes into the other side of the mount. It is basically two halves.
You will need to have your car on a lift or drive up ramps. Make sure car is secure as you will need to be under the front of it. Blue and red arrows show the bolts that need to be removed to remove that long metal mount/brace. Keep track of which bolt came from which location for re-assembly.
After the metal mount/brace is lowered to the bench or floor you just slide in the poly engine mount inserts into the stock rubber engine mount. One from each side. Red arrow shows the mount they go into.
This shows them installed. The inserts fill in the holes/gaps in the factory mount to help stop engine movement, rotation.
This photo shows the mount, brace back in location. Red arrow shows the mount. Blue arrows...make sure these rubber isolators are installed correctly...one rubber isolator on top and one below the brace with the sleeve in the center.
.Re-install and tighten all bolts!